FSAP 10.2 - Batch 1 Available

We're excited to announce that the initial version of the FSAP 10.2 software will be available tomorrow morning. As per our previous email communication, FSAP 10.2 has been approved by the BRE for completing SAP 10 compliance calculations for Batch 1 features and will available for use by all members by 9am tomorrow.

Access Tomorrow: FSAP 10.2 Software

Use the link above to access the software and email sap@stroma.com if you have any questions.

To recap on our previous communication, Batch 1 features include:

  • Building fabric (walls, roofs, floors, windows etc.)
  • Boilers (mains gas, LPG, electric, oil)
  • FGHRS
  • Secondary room heaters
  • Instantaneous WWHRS
  • Solar heating (hot water only)
  • Natural ventilation with intermittent extract fans
  • Centralised MEV
  • Decentralised MEV
  • Balanced ventilation with heat recovery (MVHR)
  • PV (without battery or diverter)
  • Air conditioning

Features and technologies for Batches 2 and 3 will not be available in FSAP 10.2 until these are approved by BRE.

Please note that all members can continue to use the current software (FSAP 2012) after the full FSAP 10.2 software is approved and released and we will advise members on which circumstances require the use of each version of FSAP.

We trust you find this update useful and will keep all members updated when further batches of technologies and features are approved by BRE over the next few weeks. We envisage that the FSAP 10.2 engine development will be fully complete no later than 31st Jul 2022.

Contact us

If you have any questions regarding FSAP 10, please don't hesitate to contact our team at sap@stroma.com